With redoing the Servo lab, I changed the code to make it turn 360 degrees. However, it doesn’t seem to move a full 360. Is this just due to the micro servo’s ability or is there something wrong?
Untitled from Lindsey Frances on Vimeo.
Here is a simple application (disclaimer: I do not approve of the use of real guns for this application.)
Servo Movement from Lindsey Frances on Vimeo.
In addition, to this I was wondering where the Duplex Serial Lab is. Serial Communication I think I understand to some extent but something is not clicking and I am not exactly sure what it is.
Sadly most Servo motors only move 180 degrees. There are some rare servos that could do 360 but not the ones that come with our kits.